David Clark 9800 Series Manuel d'installation télécharger pdf (Page 15)

9532P-62 (03-11)

of 32

rocedure

q D

etermine the location for the Panel Display. The Panel Display should be mounted on a flat

surface that is visible and accessible to the captain and co-captain. The surface can range in

thickness from 1/32 to 7/8 inches. See Figure 7.

q Be sure there is at least 6-inches of room behind the panel to attach and route the C98-20PD

Panel Display Cable.

q Using the drilling template in Figure 8, mark the location for the 1 1/4” hole on the mounting

surface.

q Drill the 1-1/4” hole using the hole-saw.

q Place the provided 3”x3” gasket over the threaded bushing of the Panel Display and mount the

Panel Display as shown in Figure 7.

q Do not over-tighten but make sure that the Panel Display will not rotate and sealing gasket is

compressed tightly.

q Attach the C98-20PD cable to the Panel Display.

q Connect the cable to the Master Station’s connector labeled “Panel Display” (see Figures 1&4).

To connect the cable to the Master Station, align keyways and push. Then firmly turn collar

clockwise until it locks into place. Pull back gently on the cable to ensure connector is properly

locked.

q Use plastic cover to protect the Panel Display when it is not in use.

igure 7: Panel Display Mounting Diagram

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 42 43

Pas de commentaire

David Clark 9800 Series Manuel d'installation Page 15